Forum: Fast Freddie

Here is a general how-to on making your own AEM serial output cable 1. Go to an electronics store or online shop and purchase a DB-9 (rs-232) female recepticle like this 2. Also purchase a DB-9 backshell like this

*Percent Low Temp Timing Trim vs Coolant Temp- all columns set to 0% *Ignition Unknown Map (Warm-up?) (AKA the Hole of 5's)- set to match high octane timing map *Startup IPW Latency msec- Matched the 14v Injector latency value *Open Loop Load #1 & #2- set to match the 96940011 rom *Open Loop...