Technical help specifically for your DSM
Here is some information I want to get out there. The 4g63 is not a small block Chevy. You do NOT crank it with the fuel disconnected or the ignition unplugged to prime the oiling system. If you truly wanted to try and prime the oiling system before starting a new engine you would need to...
My car has been sitting in my garage for a little over 3 years. I finally got around to messing with it...too many deployments. When the car showed up at the shipping station it wouldn't go into gear and made a loud screeching noise when started. I took the rubber cover off the fork and a...
Hey all, I have been out of this DSM game for sometime now and Im going to pick it back up! I have had this 1g auto all wheel sitting in my garage for a few years now and Im finally going to put it back together. I have a pile of perf. parts from when I was going to finish it but now Im questioning...
What kind of fixes do people do for the 1g awd fuel tank when some of the studs for the sending unit are gone? A lot of them on mine were gone when I got it and I don't think its keeping good pressure in the tank. Any ideas on easy you have heard of or done yourself? thx Jansen
hey guys, ive got a 97 eclipse gsx with everything rebuilt, 6 bolt swap, tail bov, gm mas airflow, 550cc injectors, 190 fuel pump, streetgate wastegate with dump, just a 14b for now, intercooler, ross 8.5 to 1 pistions, 1g rods, 264 cams, dsmlink v3. i bought the car about a year and a half...
This is an issue because it's my ONLY car right now. I have a 91 Eagle Talon TSi, that has pretty much had EVERYTHING rebuilt. Engine, head, trans, new turbo etc. I did the rebuild about 5 years ago so it's not new but up until about a year ago, this car was only driven on weekends. My other...
Finally got my 91 talon put back together and running the other day. I grounded out the sensor and set base timing like the manual says to do and then tried to set the idle but I can't get it low enough. It idles at like 1500 rpm when I unground the sensor used for setting base timing with the biss...
Ok so my left front drivers side CV boot was cracked, I went to O'reilleys to get a new boot. Dealer is on crack $93 for a CV boot. Entire replacement axle was $50, so I went that route. Anyway I got the axle separated with a BFH. Now I need to get the axle back in the intermediate shaft. I cant...
Ok, so Ive done a lot of searching and read quite a few people with this problem. I have heard "Its probably normal" I guarantee it isn't. The sound isn't always consistent. Sometimes I get driveline vibe with it, sometimes I dont. This is my 5th DSM and I have never had anything close to this...
Looked it up and its this stupid thing: My question is this: HOW THE HELL DO I KILL THIS CELL CODE!? Because I can't find one o the soleniods and its annoying and doesn't do ANYTHING. BTW this is on a bone stock 1997 GST
I have a 1991 talon looking for any one that knows how to hard wire the hks vpc
Well I got the motor together and in and hooked up. Now the problem I'm running into is I'm not getting spark or fuel. But everything else works, from power Windows to radio to heat and lights. But no fuel or spark. My guess is the ecu took a crap. But before I go buy another ecu I was wondering if...
Okay first of I have a 1990 laser rs-t. Im going to be running a 20g, fmic, wally 255, aeromotive fpr, lightly ported head, stock came, 3" downpipe, 3" exhaust, no cats 1 senator. I would like to know how big Injectors I should think about running. I will probably be tuning by safc for now. I don't...
I own a 1995 Sonata GLS 2.0 liter DOHC and I would like to get a OBDii adaptor to work on my hand held 16 pin scanner device. Anyone know where I can get this adaptor? email me at: v_trestrail@hotmail.com Thanks!
Ok my buddy has a 92 talon tsi awd 462 hp 372tq on e85 with aem ems fuel is fed by a buschar racing double pumper with dual 255s and 1600cc injectors and the list keeps going . Now the problem is it keeps eating starters over and over agian don't know why! So Ive come here today hoping someone...
Ok I am horrible at electrical work and I am looking for someone to walk me through this.
Hi, I was just wondering what your guys' experience with timing in camshafts was. I have Kelford 272's and im just about ready to time the car. Kelford sent me specs on the camshafts, but im really wanting to know if its really necessary (I did however order the degreeing kit the other day). The...
I am installing a new one and dont remember how the oil seperator faced.
So I need to pick up a wideband but not sure if I should get an aem uego or an autometer cobalt to match all my other gauges, anyone have experience with either?
I have this laying around and have no idea what it is.
i just got my 1993 eagle talon to fire up 2day but none of the gauges are working on the cluster i tired switching the cluster but dose same thing any advise is much appreciated.
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules