1st pull since swapping some parts= no bueno

[mullen]

To start with an example the last time i was on a dyno was 2 years ago at buschur where i laid down 320hp and 310 tq on 93 octane using a ebay fmic,injen ic piping, bc272 and ebay exhaust...Since then ive been swapped to a ported 10.3 hotside,and every other buschur bolt on. As of lately i swapped my deluxe fmic for a br race fmic and in between that my egr went bad so heres the crap...[IMG][/IMG]
this is on 91 octane and i let off at around 7k because it felt like shit

[mullen]

i actually let off earlier than i though at about 6600, ill try another pull but it just feels like shit according to my ass dyno...i think i have a slight boost leak
also this is using the dynojet settings so my power must be way down

[mullen]

also i double checked the datalog and at the end of my pull my injectors were at 98% duty cycle

[Rogue]

without a wb02.. its impossible to get an idea of whats going on.

is your power down because your overly rich? Hows timing?

[Spoolin0nYou]

What are your compression #'s, John?

[mullen]

im going to try and weld the bung on the downpipe in the next few days so i can use my wb o2
as for the compression, im unsure....

[project_skyline]

How much boost? Post some logs up or email some to me.

You still running the bc272's? You should post a complete current mod list anyway.

[mullen]

21psi settling at 19 i believe
my current mod list is the bc272s,ported exhaust manifold and ported 10.3 hotside,buschur ss 02 housing and 3" turbo back exhaust, race fmic and short route piping

[David Buschur]

Get those cams out of that car! You couldn't run a worse cam.

Let me know when you want tuned, after the cam swap and I'll get you over here and get the car sorted!

[mullen]

im planning on swapping to bf272s when i order a shortblock and put the fp black on

[mullen]

How much boost? Post some logs up or email some to me.

You still running the bc272's? You should post a complete current mod list anyway.

pm me a list of logs you'd like

[mullen]

here is a pull from today after i deleted the egr
[IMG][/IMG]
still no good

[mullen]

is it normal for my timing advance to fluctuat from 7-17 while idling
while my "knock_adc_processed" stays around 1-6
and my knock base stays at 10

[yellowevo42]

gotta find out whats happening with the compression..